Wonderful Info About How To Check Shock Absorbers

Make the car stand on one horizontal level.

How to check shock absorbers. Mount on the chassis to the lower shock mount on the di˜ to get the full compressed closed length of the shock absorber. The simplest one is to rock the car body. How do you check rear shock absorbers?

That was him checking the shocks. How to check shocks and struts in your car diy with scotty kilmer. Shocks aren't universal in length or fitment.

There are three methods of how to check shock absorbers. Park your jeep in a level position and turn off the ignition. Push the car down and it should rise back up slightly slower than it went down.

Measure the extended side of the vehicle from the top shock mount on the body chassis to the lower shock mount on the di˜ to get the full extended open length of the shock absorber. You can check the condition of your shock absorbers by following these steps: When you park your car flat on the ground, view from a distance if it leans on one side than the other.

It is necessary to rock the front and the rear part of the body in turn to. If it bounces right back like a rubber ball, the shock. Below you can read in detail the individual symptoms of bad or worn shocks and struts to determine if you need to have your shocks and struts replaced.

After this, look carefully, if the tank, under the action of the springs, rises and stops, the shock absorbers. How tell if you need new shocks or struts in your car. Find a part number somewhere on the shock, this isn't always feasible, but as a last resort it could help out.